Simulasi sederhana pada hukum pendinginan Newton


DOI: https://doi.org/10.30998/npjpe.v3i1.475

Iman Noor(1*), Andry Fitrian(2),

(1) Universitas Indraprasta PGRI
(2) Universitas Indraprasta PGRI
(*) Corresponding Author

Abstract


A simple simulations on Newton’s cooling law has been performed. This simulations aims to study correlation of the newton cooling constant at temperatures to cooling times. This reseach is displayed in GUI Matlab (Guide Using Interface).  The input required is initial temperature, ambient temperature, cooling constant, and cooling time. Through numerical calculation of the Newton’s cooling equation with Eulerian Method, we got that the time to reach the ambient temperature of each cooling constant is 59 seconds, 31 seconds, and 20 seconds respectively.

Full Text:

PDF

References


Guswantoro, T. (2017). Penggunaan Pasco Capstone 14.1 untuk menentukan koefisien konveksi udara dengan metode pendinginan air. Jurnal EduMatSains, 1(2), 165-176

Irawati, E., Huda, C., & Kurniawan, W. (2019, November). Pengembangan Alat Peraga Perpindahan Kalor secara Konduksi, Konveksi, dan Radiasi dalam Satu Set Alat berbasis Digital. In Seminar Nasional Lontar Physics Forum (pp. 86-91).

Nazar, A. J. (2016). Studi Eksperimen Aliran Melalui Square Duct Dan Square Elbow 90o Dengan Double Guide Vane Pada Variasi Sudut Bukaan Damper (Doctoral dissertation, Institut Teknologi Sepuluh Nopember).

Ningsih, S., & Srigutomo, W. (2018). Perpindahan Panas pada Media Berpori Menggunakan Metode Elemen Hingga. SAINTIFIK, 4(2), 167-178.

Nirwana, L., & Rais, M. (2020). Konduktivitas Termal Pasir Kali Sebagai Media Penghantar Panas Pada Proses Penyangraian Kerupuk. Jurnal pendidikan teknologi pertanian, 3, 182-196.

Noor, I., & Fitrian, A. (2019). Simulasi sebaran temperatur pelat logam tipis besi dan kuningan berbasis Matlab. Navigation Physics Journal, 2(1), 9-13.

Ramadhan, F. (2019). Analaisa Numerik Pada Struktur Blok Silinder Mesin Dengan Variasi Diameter Tabung Silinder (Doctoral dissertation).

Sardjito, S., & Yuningsih, N. (2020, September). Koreksi Suhu Kalorimeter sebagai Konsekuensi Laju Pendinginan oleh Suhu Lingkungan pada Percobaan Tara Kalor Mekanik. In Prosiding Industrial Research Workshop and National Seminar (Vol. 11, No. 1, pp. 705-709).

Supu, I., Usman, B., Basri, S., & Sunarmi, S. (2017). Pengaruh suhu terhadap perpindahan panas pada material yang berbeda. Dinamika, 7(1), 62-73.

Suryani, N., & Santosa, I. E. (2014). Pengukuran konstanta pendinginan newton. Prosiding Seminar Nasional Sains IX Fakultas Sains dan Matematika UKSW. https://repository.uksw.edu/bitstream/123456789/4542/2/PROS_N%20Suryani%2C%20Ign%20E%20Santosa_Pengukuran%20Konstanta_fulltext.pdf

Widyastuti, W., & Ishafit, I. (2019). Penentuan Kalor Jenis Bahan menggunakan Metode Pendinginan Newton dan Sensor Suhu DS18B20 Berbasis Arduino Uno (Doctoral dissertation, Universitas Ahmad Dahlan).




DOI: https://doi.org/10.30998/npjpe.v3i1.475

Article Metrics

Abstract Views : 9494 | PDF Views : 3711

Refbacks

  • There are currently no refbacks.


Copyright (c) 2021 Iman Noor, Andry Fitrian

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Department of Physics Education
Faculty of Mathematics and Sciences
Universitas Indraprasta PGRI

Address: Jl. Raya Tengah No. 80, Kel. Gedong, Kec. Pasar Rebo, Jakarta Timur 13760 , Jakarta, Indonesia. 
Phone: +62 (021) 7818718 – 78835283 | Close in sunday and public holidays in Indonesia
Work Hours: 09.00 AM – 08.00 PM
Best hours to visit: From 9 am to 11 am or after 3 pm. The busiest times are between 11 am and 3 pm. 

Creative Commons License
Navigation Physics: Journal of Physics Education is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.